THE BHARAT ENGINEERING METAL WORKS

MANUFACTURER, EXPORTER, IMPORTER & DEALER OF SHEET METAL MACHINERY AND INDUSTRIAL MACHINERY

UNDER CRANK TYPE
Capacity: Length - 1250 mm, 1800 mm and 2500 mm.
Thickness - 2 mm, 3 mm, 4 mm & 5 mm

OVER CRANK TYPE
Capacity: Length - 1250 mm and onwards Thickness - 6 mm ( 1/4") and onwards



CONSTRUCTION

BODY
Frames are completely mild steel thick plate fabrication, sides are welded strongly for utmost rigidity, and break proof under heaviest load. For thick plate cutting, over crank machine's sides are thick welded plates and also double wall lateral frames for extra thick cutting.

TABLE
Table is welded construction. Strong utmost rigidity and break proofness and under heaviest loads.The proper distance between the blades can be set precisely by set screws on the top holder beam of the top blade. On the table, the blade is bolted in straight line. Thin sheet can be cut thus free from Twists and Burr.

TOP
Top Holder is also welded construction, Gun metal guides are bolted on the sides and at the back side, top cast iron guides are provided by set of screw bolts, so top can move up and down freely in such guides.

SETTING THE GAP BETWEEN THE BLADES
A decisive fact or the quality of the cut is the gap between the blades,which corresponds to the thickness of plates. Gap is adjusted by a system of sturdy threaded bolts on the table,also adjustment can be done by top holder setting bolts.

CLUTCH
Clutch and Brake have been arranged on the main shaft of the gear. Clutch will be 'Rush Worth' Rolling key type for Under Crank Machine. Dog clutch will be provided to Over Crank Machine. Eccentrics are cast iron and arms are mild steel fabrication. Start is effected by foot pedal. Continuous stroke has been provided by putting leg on the pedal. Gears & pinions will be steel single helical gears, single and double Gears and pinions arrangement will be done as per the cutting capacity.

SHAFTS
All Shafts are Propeller or forged Axle Bars, eccentrics, gears, pinions and brake are fixed with suitable keys. Gun metal bushes with suitable oil holes are on all shafts. Ball bearings will be on counter shaft, V-Belts flywheel and balancing flywheel are on the counter shaft with suitable keys.

GAUGE
Front gauge with scale will be on the table, Tee-bolts will be provided for the adjustment of width of the Sheet / Plates. The Back gauge will be fixed on top arm and adjustment will be done by rack on machined round shaft and pinions are on the shaft with hand wheel will provided for movement of back gauge.

HYDRAULIC ARRANGEMENT
Instead of gearing, top arm can be operated hydraulically if required.

DRIVE
Drive is powered by standard squirrel cage induction electric motor, 960 RPM, totally enclosed type with suitable V-Belts, switch and starter are provided for protection of motor.

TOP OF PAGE

Website developer : KUSHALtechnology